CVM Fiber and Industries

CVM Fiber and Industries · 17 November 2026

Growing Gerbera in Coco Coir: Pots, Crown Rot, Feeding

Gerbera on coco coir in pots and bags: planting depth, crown rot and Phytophthora, irrigation timing, feed EC and pH, iron, drain reuse and crop life.

The short answer: gerbera is one of the crops coir suits best, as long as you keep the crown dry and the substrate airy. Grow one plant per pot or bag, set the crown 1 to 2 cm above the coir surface, use a coarse blend rather than fine pith, and water in short pulses that stop several hours before dark so the root zone dries back overnight. Feed at about EC 1.5 to 2.0 mS/cm at pH 5.5 to 5.8, watch iron closely, and don't let drain EC run more than about 20% above the feed. Most gerbera losses in coir are crown rot and root rot from substrate that stays wet, and both are easier to prevent than to cure.

Key figures

  • Density: about 6 to 9 plants per m², one plant per pot or bag.
  • Crown height at planting: 1 to 2 cm above the substrate surface.
  • Feed EC: 1.5 to 2.0 mS/cm in most substrate crops, up to 2.2 to 3.0 in some soilless protocols.
  • Feed pH: 5.5 to 5.8. Gerbera shows iron chlorosis quickly above about 6.0.
  • Irrigation: pulses of around 200 ml, 6 to 8 a day in summer, none in the last four hours before dark.
  • Crop life in the same pot: usually two to three years.

Where gerbera is grown in coir

The Netherlands has grown gerbera on substrate for decades. Growers there moved from soil to stone wool and many have since moved to coir, and Dutch rules require soilless growers to collect and recirculate their drain. The result is a crop grown in individual pots or small bags on raised gutters, with every litre of drain caught, filtered, disinfected and reused.

India has a large gerbera industry in polyhouses around Pune, Bengaluru and in the hill states. Much of it still grows on raised soil beds, often improved with coco peat, rice husk and compost, because soil beds are cheap and forgiving of unreliable power. Substrate growing in coco peat bags and pots is spreading, especially where soil disease has built up after a few crops.

In a comparison of coir and stone wool in open and closed systems, the number of flowering stems was the same on both. Coir gave somewhat shorter but heavier stems. For most markets that is a fair trade, and coir is cheaper to dispose of.

Pots, bags or beds

Gerbera moved off long slabs because one diseased plant in a slab infects its neighbours through the shared root zone. With one plant per container you pull the sick plant and the rest of the row carries on.

System How it works Points to watch
Individual pots, 20 to 25 cm diameter One plant per pot on a gutter or wire, drain collected below Most common in the Netherlands. Easy to rogue out sick plants
Open-top coir bags or small slabs per plant Pre-filled, hydrated in place Cheap to set up. Make sure each plant has its own volume
Raised beds of soil and coco peat Beds about 30 cm high, two rows of plants Common in India. Cheaper, but disease spreads along the bed

Whatever the container, get it off the floor. A pot standing in its own drain puddle is a pot waiting for Phytophthora. If you are choosing between formats, open-top bags vs slabs compares them.

The right coir for gerbera

Gerbera wants more air in the root zone than roses or tomatoes. Fine, dusty pith holds too much water near the crown. Look for:

  • A coarse pith with plenty of long fibre, or a pith and husk chip blend.
  • Coir with perlite added at 25 to 50% by volume. Mixes between 50:50 and 75:25 coir to perlite have given the best growth and the most flowers in trials.
  • Low sodium and low EC after washing. Gerbera is salt-sensitive at planting.

The pith to husk chip ratio guide shows how much air each extra share of chips adds.

Planting and the crown

Gerbera young plants come from tissue culture, hardened in plugs before they reach the grower. The single most important thing at planting is depth.

  1. Hydrate the pots or bags fully before planting and flush until drain EC is close to the feed EC.
  2. Set the plant so the crown sits 1 to 2 cm above the coir surface. The top of the plug should be at or just above the surface, never buried.
  3. Water the plug, not the whole pot, for the first days. Let roots grow out into a pot that is moist but not saturated.
  4. Don't top up the pot later. Coir settles a little in the first weeks, and growers are tempted to add more around the plant. That buries the crown. Leave it.

A crown buried in wet coir is the commonest route to crown rot in gerbera. The crown tissue is soft, it stays wet, and fungi that live in the substrate get in through tiny wounds.

Crown rot and root rot

Three disease groups do most of the damage in gerbera on substrate.

Phytophthora crown and root rot (mainly Phytophthora cryptogea). The crown turns black and soft, leaves wilt and collapse, and the plant dies within days. It spreads in water, so in a recirculating system one infected pot can seed the whole house. Chemical products have given inconsistent control.

Pythium root rot. Brown, soft roots with the outer layer slipping off. Plants wilt on bright days, then recover at night, then stop recovering. Pythium thrives in substrate that stays wet and in warm water.

Fusarium wilt. Yellowing on one side of the plant, brown streaks inside the crown. Spread by infected young plants and in drain water.

The common factor is water. In one recirculating gerbera trial without fungicides, the wettest, lowest-EC treatment lost about three-quarters of its plants, while the driest, highest-EC treatment lost fewer than one in twenty. Prevention in coir looks like this:

  • Keep the crown above the surface and dry.
  • Stop irrigating about four hours before dark so the pot dries back overnight.
  • Use a coarse blend and keep pots off the floor.
  • Filter and disinfect drain before reuse. Filtering alone doesn't remove pathogens. Heat or UV after filtration does.
  • Pull sick plants with their pot and coir, bag them in the house and take them out. Don't empty them on the floor.
  • Clean and disinfect pots between crops.

More detail on wet-root diseases in coir is in root rot and Pythium in coco coir.

Irrigation timing

Gerbera is more sensitive to over-watering than to a short dry spell. The usual plan is short pulses through the day.

  • Pulses of about 200 ml per plant in a free-draining pot.
  • Six to eight pulses a day in summer, fewer in winter.
  • First pulse once the plants are transpiring, not at dawn.
  • No irrigation in the last four hours before dark.
  • Daily use runs about 500 to 700 ml per plant in Indian polyhouses and 800 to 1,200 ml in southern European greenhouses in summer.

Weigh a few pots each morning or use a substrate sensor. If the pot is as heavy at dawn as it was at dusk, it isn't drying back and the next day's irrigation should start later. The same rule about stopping in the afternoon applies to soil-and-coco-peat beds.

Feeding gerbera in coir

Item Working range Notes
Feed EC 1.5 to 2.0 mS/cm Some soilless protocols go to 2.2 to 3.0. Indian growers on coco peat often run 1.2 to 1.5
Drain EC not more than ~20% above feed Higher means salt is building
Feed pH 5.5 to 5.8 Substrate pH 5.2 to 6.3 is acceptable
Iron keep supply high, chelated Gerbera yellows quickly at high pH
Calcium and magnesium extra for the first weeks on unbuffered coir Coir exchange sites take up Ca and Mg

Two points are specific to gerbera.

Iron. Gerbera is one of the quickest crops to show iron chlorosis. Young leaves go pale yellow with green veins, often after a period of wet, cold roots or when root-zone pH drifts above 6.0. Keep the feed pH low, use an iron chelate that stays available at the pH you run, and look at the roots first if leaves yellow. Waterlogged roots can't take up iron however much is in the feed.

Starting chemistry. In gerbera, untreated coir has produced fewer flowers than coir that was pre-treated or blended. Coir straight from washing carries potassium and sodium on its exchange sites and takes calcium and magnesium from the feed until those sites fill. With washed, unbuffered coir, saturate the pots with a calcium-rich feed before planting and run extra calcium and magnesium for the first month while you watch the drain. Buffered vs unbuffered coco peat explains the exchange in more detail.

Drain reuse

Collecting and reusing drain saves fertiliser and water and is required in some countries. It also means a single infected pot can spread disease through the whole system. A working setup filters drain, disinfects it by heat or UV, measures EC and sodium, and blends it back with fresh water. Sodium creeps up over the season in a closed system, so bleed off part of the drain when sodium rises past what the crop tolerates. See drain water recycling with coco coir for the equipment and the numbers.

Crop life and replanting

A gerbera crop usually stays in the same pots for two to three years. Production is highest in the first year and slowly falls as plants age. Coir pots hold up for that period if the blend was coarse. When you replant, empty the pots, wash and disinfect them, and refill with new coir. Reusing old gerbera coir under a new gerbera crop carries disease risk that rarely makes the saving worthwhile.

FAQ

How deep should gerbera be planted in coir?

Set the crown 1 to 2 cm above the coir surface, with the top of the plug at or slightly above the surface. Never bury the crown and don't top up the pot later as the coir settles. A crown sitting in wet substrate is the commonest cause of crown rot.

What causes crown rot in gerbera and how do I stop it?

Crown rot is usually caused by Phytophthora, often Phytophthora cryptogea, getting into a crown that sits in wet substrate. Plant high, use a coarse coir blend, keep pots off the floor, stop irrigating about four hours before dark, disinfect reused drain and remove sick plants with their pot and coir as soon as you see them.

What EC should I feed gerbera in coco coir?

Most substrate gerbera crops run a feed EC of 1.5 to 2.0 mS/cm at pH 5.5 to 5.8. Some soilless protocols go up to 2.2 to 3.0, while many Indian growers on coco peat run 1.2 to 1.5. Keep drain EC no more than about 20% above the feed.

Why are my gerbera leaves turning yellow in coir?

Pale young leaves with green veins are iron chlorosis, common in gerbera. Check root-zone pH first and keep the feed near 5.5 to 5.8. Then check the roots. Wet, cold or rotting roots can't take up iron, so a drainage problem often looks like a nutrient problem.

Can I grow gerbera in coco peat on raised beds?

Yes. Many Indian polyhouses grow gerbera on raised beds of soil improved with coco peat and compost. Beds are cheaper, but disease spreads along them more easily than in individual pots. Keep beds well drained, plant the crown high and don't irrigate late in the day.

Coir for gerbera growers

CVM Fiber and Industries in Kanyakumari, Tamil Nadu, India supplies washed coco peat, husk chips and pith and chip blends for gerbera pots, bags and beds, in open-top bags or compressed blocks. Our coir is washed with water only and is not buffered. Every batch is tested, and export shipments carry a phytosanitary certificate. Tell us your pot size, the blend you want and how you plan to start the crop, and we will quote: get in touch.